Are you planning to install Perform Panel solid bathroom and shower wall panels but don’t know where to start? Don’t worry! The following this comprehensive guide will provide detailed instructions on installing solid bathroom shower wall panels properly.
Step 1: Gather Tools and Materials
Before you begin, gather the necessary tools and materials:
- Solid bathroom shower wall panels
- Measuring tape
- Spirit level
- Adhesive specifically designed for wall panels
- Sealant
- Screws and wall plugs (if necessary)
- Saw or utility knife
- Screwdriver
- Notched trowel
- Caulking gun
- Spacer wedges
Step 2: Prepare the Surface
- Ensure the wall surface is clean, dry, and free from dust, grease, and loose material.
- Repair any existing wall damage or unevenness to ensure a smooth surface.
Step 3: Measure and Plan
- Measure the height and width of the shower area where the panels will be installed.
- Cut the panels to the required size using a saw or utility knife, ensuring precise measurements for a snug fit.
Step 4: Apply Adhesive
- Use a notched trowel to apply adhesive to the back of the panel, following the manufacturer’s instructions for application.
- Ensure that the adhesive is applied evenly and covers the entire back of the panel.
Step 5: Position the Panels
- Carefully position the first panel, starting at one corner.
- Use spacer wedges at the bottom to maintain a gap between the panel and the shower tray or bath.
- Check the panel with a spirit level to ensure that it’s level vertically and horizontally.
Step 6: Secure the Panels
- If necessary, use screws and wall plugs to secure the panels to the wall, being careful not to overtighten and damage the panels.
- Some panels have tongue-and-groove or interlocking edges, which can hold the panels in place without screws.
Step 7: Repeat for Additional Panels
- Continue fitting the panels individually, using spacer wedges to maintain consistent gaps.
- Ensure proper alignment both horizontally and vertically, with no gaps between panels.
Step 8: Trim and Cut as Needed
- Trim or cut panels to fit around fixtures, corners, or edges using a saw or utility knife, ensuring accurate measurements and a clean, precise cut.
Step 9: Seal the Joints
- Seal the joints between panels with a waterproof sealant using a caulking gun.
- For a neat finish, smooth the sealant with a wet finger or a caulk smoothing tool.
Step 10: Clean and Finish
- Remove any excess adhesive or sealant while wet.
- Allow the adhesive and sealant to cure per the manufacturer’s instructions before using the shower.
Step 11: Final Inspection
- Double-check that all panels are securely in place, with no gaps or loose areas.
- Ensure the installation is aligned correctly and visually appealing.
While you can install solid bathroom shower wall panels on your own, it’s advisable to consult a professional for complex installations or if you’re unsure of your abilities to ensure a watertight and visually appealing result. With the proper tools and materials and these detailed instructions, you can easily install solid bathroom shower wall panels.
For more information, please feel free to contact us at Perform Board.